One Design, 3 Sizes

  • Toddler Bed

    Given the length of this bed, it has only 10 slats. The rest of the construction is exactly as the twin size bed. 

    *Accommodates a Full Size Crib Mattress*

  • Twin Size

    This size is the exact one presented in the video below.

  • Full Size

    Follow the video until minute 4:11 and then follow the instructions below the video. 

    Attention! Predrilled holes on G must face the inside of the bed.
Questions & Replacement Parts Requests

Twin Size Floor Bed - Step by Step Instructions

Full Size Bed - Last Steps

Adding the Support Beam

Adding the Support Beam

a. Use 3 S short bolts to attach part J to the outside of L1, K1, and K2.

b. Join the two O parts using the WD wooden dowels to form the Center Support Beam. Attach one Y connector plate to each end using 2 P screws per plate.

c. Position the Center Support Beam between the G rails. Secure each Y connector plate to the corresponding G rail using 2 P screws per plate.

Mounting the Slats

Mounting the Slats

  • Place the slats on the rails attached to L1 and L2. Alternate between M1 and M2, starting and ending with an M1 slat.

  • Align each slat with the pre-drilled holes on L1 and L2 to ensure correct spacing.

  • Secure each slat to L1 and L2 using R screws.

  • Secure each M2 slat to the Center Support Beam (O) using one additional R screw through the center hole.